Day 2: Draw the shapes and the outline of the different parts on the wood.
 

Unlike yesterday, today I had some legitimate work that I was supposed to do. Today's task was to make the outlines of the different parts of the surfboard on the wood. It was an exciting day because finally I was beginning on my project.  It was also a difficult task because I needed to be very accurate and draw it properly so that I do not regret the drawing after cutting the wood. I tried my best to draw the figures and the outline accurately and I think I did a pretty good job. Firstly, I started with the drawing of the main surfboard because that is what I will be cutting tomorrow. It took a very long time for me to draw it because first I measured the length and the width and marked it accordingly. Then I tried to make the curves of the surfboard equal and equidistant from the center. I was not very successful at this because the curves of the surfboard did not look as uniform as I wanted them to be. I tried my best to make it look uniform, but did not completely succeed. Drawing the other parts was much easier because I had all the measurements and the dimensions and had to just measure and draw on the board. I did all of them in a matter of about 1 hour. The wooden board was so big that I had to sit on it in order to draw on it! I did not face much challenges except for the part when I had to draw the actual surfboard. The bigger challenge will be tomorrow when I will have to carry that big and a hevy board and walk to school. I think I shoudl arrange for a drop from my father so that it will be easier. This was today's work and this is how the outlines of the different parts look like: